Laboratory analysis instrument installation conditions

Before the lab analysis instrument is installed, its laboratory should have the following conditions:

1, the determination of the laboratory location
In the factory area, the laboratory should be built away from major roads and large earthquake sources, and there should be a workshop with a large number of smoke and dust.

2, laboratory safety measures

The vast majority of chemical drugs are toxic, some drugs are highly toxic, some are highly corrosive, and some are flammable and explosive drugs. Therefore, attention must be paid to classified storage. The qualified laboratories should establish dedicated storerooms for medicines, etc., and fireproof facilities should be provided indoors.

3, the overall design of the laboratory

According to the characteristics of testing materials and elements, each sub-committee is set up to scientifically arrange and place instrumentation equipment, arrange power lines, water pipes and sewage discharge pipelines, and provide reasonable lighting, natural ventilation and lighting.

4, laboratory power equipment

The diameter of the power wire diameter introduced into the laboratory should be determined based on the total power of the laboratory equipment. The power of the laboratory should be equipped with dedicated lines and good grounding. The power supply is a 220V single-phase three-wire power supply. Note that the grounding must be good. Each area of ​​the laboratory must have a power outlet. The outlet depends on the instrument plug. Note that a carbon-sulfur analyzer arc furnace should use a well-grounded single-phase three-wire power outlet.

5, the client table may be purchased <br> <br> reagent racks placed on the laboratory bench scale straw, such as a test tube readily desirable operation, convenient and practical, to maintain a certain distance from the subject equipment, laboratory bench near the pool At one end, it can be used to prepare various types of reagents, as well as a platform for chemical operation. It is convenient for the rinsing of glass tubes after the operation. The rest of the laboratory bench is used for the placement of major instruments, and the balance, carbon and sulfur analyzers and The other element analyzers can be reasonably placed according to their own conditions. General: The carbon-sulfur analyzer series analyzer is set on the test bench position of the oxygen cylinder. Place scales, test benches, and other element analyzers at the corners. It is important to note that the spacing between the main instruments must be slightly larger to prevent the mutual corrosion of the reagents and the influence of the operating temperature and voltage.